Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 115
4.2.15 PE Sensor Unit Removal
1. Remove HOUSING. (Refer to Section 4.2.1)
2. Remove the ASF Unit. (Refer to Section 4.2.10.)
3. Remove the DE Unit. (Refer to Section 4.2.9.)
4. Remove PAPER GUIDE, RIGHT Unit. (Refer to Section 4.2.13.)
5. Remove the timing belt. (Refer to Section 4.2.11.)
6. Release the two hooks securing the PE sensor unit to FRAME, TOP, lift
up the PE sensor unit, and then remove it to the rear.
Figure 4-66. PE Sensor Unit Removal
CHECK
PO INT
When installing the PE Sensor Unit, ensure that the
sensor lever is set in the square hole in PAPER GUIDE,
RIGHT Unit. (See Figure 4-59.)
PE Sensor Unit
Hooks