Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 86
ADJUSTM ENT
REQUIRED
When you replace the Printhead Unit, perform the
following adjustments:
1. Initial ink charge (Refer to Chapter 5/Section 5.1.1.)
2. Head Voltage ID Input (Refer to Chapter 5/Section
5.1.2.)
3. Head Angular Adjustment (Refer to Chapter 5/Section
5.1.3.)
4. Bi-D Adjustment (Chapter 5 /Section 5.1.4.)
CHECK
PO INT
!
When installing FASTENER, HEAD, first fasten the two
screws (CBP, 3x6) securing FASTENER, HEAD and the
CBB Sems W2 (M2.5x6) temporarily, and then attach the
torsion spring. After that, fasten the screws tightly.
!
When installing FASTENER, HEAD to the Carriage Unit,
fasten the screws in the following order:
1) CBP (3x6) on the right
2) CBP (3x6) on the left
3) CBB Sems W2 (M2.5x6)