Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 97
4.2.10 ASF Unit Removal
1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Remove the following cables from the cable clamp in the left side of
the ASF Assembly.
!
ASF HP sensor cable
!
MOTOR ASSEMBLY, PF cable
3. Disconnect the ASF HP sensor cable from the connector on the
sensor.
4. Remove the head FFC from the ASF Unit.
5. Remove the one screw (CBS Sems, 3x6) and SHAFT, MOUNT, CR that
are securing the ASF Unit to FRAME, BOTTOM at the rear right and
rear left, respectively.
Figure 4-29. ASF Unit Removal (1)
6. Tilting the paper support sub unit, release the hook fixing the ASF
Unit to FRAME, BOTTOM, and remove the ASF Unit toward the rear.
Figure 4-30. ASF Unit Removal (2)
Figure 4-31. ASF Unit Removal (3)
ASF viewed from the left
ASF viewed from the right
CBS Sems (3x6)
SHAFT, MOUNT, CR
Paper Support Sub Unit
Hook in the ASF Unit