Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 98
Figure 4-32. Check Points in ASF Assembly
CHECK
PO INT
!
When installing the ASF assembly to FRAME, BOTTOM,
make sure the protrusion on the ASF fits in the
installation hole in FRAME, MIDDLE. (See Figure 4-32.)
!
When installing the ASF Unit, ensure the spur gear 32 in
the ASF Unit and the inner gear of the combination gear
(14, 28) in the DE Unit are meshed. (See Figure 4-32.)
!
When installing the ASF Unit, make sure the Hopper
Assembly is raised.
Stylus Photo 870
Stylus Photo 1270
Protrusion
Gear 32
Installation Hole
Gear 32
Combination Gear
14, 28
Installation Hole
Protrusion
Combination Gear
14, 28
CHECK
PO INT
!
When connecting the cables for ASF HP sensor and
MOTOR ASSEMBLY, PF, set them in the cable clamp in
the rear left part of the ASF Unit as shown in the figure
below:
Cable Clamp