Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 99
4.2.10.1 SHAFT, ROLLER, LD Removal
1. Remove the ASF Unit. (Refer to Section 4.2.10.)
2. Releasing the hook on Gear, 32, remove the gear from SHAFT,
ROLLER, LD.
Figure 4-33. SPUR GEAR, 32 Removal
3. Remove LEVER, HOPPER, RELEASE from the right end of SHAFT,
ROLLER, LD.
4. Remove HOLDER, SHEET, PAPER FEED from the right and left LD
roller units.
5. Move the left LD roller assembly to the middle and then:
Stylus Photo 870:
Remove BUSHING, FIXING, LEFT from the left end of
SHAFT, ROLLER, LD
Stylus Photo 1270:
Remove the E-ring from the left end of SHAFT,
ROLLER, LD.
Figure 4-34. BUSHING, FIXING, SHAFT/E-Ring Removal
6. Move SHAFT, ROLLER, LD to the left.
7. Release the fixing tab in WHEEL, DETECTOR, and then remove
WHEEL, DETECTOR from SHAFT, ROLLER, LD.
Figure 4-35. WHEEL, DETECTOR Removal
HOLDER, SHEET,
PAPER FEED
LEVER, HOPPER,
RELEASE
Hook
SPUR GEAR, 32
Stylus Photo 870
Stylus Photo 1270
BUSHING, FIXING,
SHAFT, LEFT
E-Ring
WHEEL, DETECTOR Fixing Tab
SHAFT, ROLLER, LD