Specifications

EPSON Stylus Photo 780
4 -
EPSON Stylus Photo 780 1/01
.
A: The maximum top margin is 0.67 inch (17.0 mm).
L & R: The maximum left and right margin is 0.24 inch (6.1 mm).
The minimum left and right margin is 0.12 inch (3.0 mm).
C: The maximum bottom margin is 0.24 inch (6.1 mm).
* EPSON 4
×
6-inch Photo Paper is 4.5
×
6.9 inches
(114.3
×
175.3 mm), including the perforated margins. The
printable area is 4
×
6 inches (101.6
×
152.4 mm).
To ensure good results, use genuine EPSON cartridges
and do not refill them. Other products may cause
damage to your printer not covered by EPSON’s
warranties.
Don’t use an ink cartridge if the date on the package has
expired.
Control Panel
You can diagnose some problems by checking the printer’s
control panel lights, as described below, or running a printer
check, as described on page 5.
Installing Ink Cartridges for the First
Time
1. Lower the printer’s output tray (A) and open the cover (B).
2. Plug in the printer and press the Ppower button to turn
it on.
P is on The Ppower light is on when the printer is ready to print.
It flashes when the printer is receiving a print job, charging
ink, or cleaning the print head.
A
L & R
C
EPSON 4
×
6-inch
Photo Paper *
(dotted lines indicate
perforations)
power button
maintenance
button
ink cartridge
replacement
button
power light
error light
b
is on When the
b
error light is on, paper is out or loaded
incorrectly, or you have a paper jam. If necessary, load or
reload paper and press the
b
maintenance button. If
paper is jammed, press the
b
maintenance button to try
to clear the jam. If that doesn’t work, turn off the printer
and gently pull out all the paper. Turn on the printer and
press the
b
maintenance button to resume printing.
When the
b
error light is on and your paper is loaded
correctly and not jammed, you need to replace an ink
cartridge. Determine which cartridge is out of ink and
replace the cartridge as described on page 6.
b
flashes When the
b
error light flashes, your ink supply is low.
Determine which cartridge is low as described on page 7
and make sure you have a replacement cartridge.
P is off
and
b
is on
When the Ppower light is off and the
b
error light is on,
jammed paper may be blocking movement of the print
head. Turn off the printer, open the cover, and check
inside for any jammed paper. Then turn the printer back
on. If the lights are still in the same state, contact your
dealer or EPSON.
P and
b
flash
When both lights flash as you’re replacing an ink cartridge,
the flash pattern indicates which cartridge is low on ink, as
described on page 7.
If you’re not replacing ink but both lights are flashing, your
printer may have an internal error. Turn off the printer,
wait a few seconds, and turn it on again. If the lights still
flash, contact your dealer or EPSON.
P and
b
are off
When both lights are off, the printer is not receiving
power. Try these solutions:
❏
Make sure the printer is turned on.
❏
Turn off the printer, plug in the power cord securely,
and turn on the printer again.
❏
Make sure the outlet is operable and is not controlled
by a switch or timer. If in doubt, try using another
outlet.
A
B