Continuous Ink Supply System for Epson Stylus Installation Photo 830u Instruction For ST Prefilled Version With Auto Reset Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole operation is very easy. It’s really an effective tool to save your money.
CIS for EPSON Stylus Photo 830u Instruction Thank you for purchasing ST Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing ST Continuous Ink Supply system.
Put the CISS on the left side of the printer. In the meantime place all the tubes at correct position. Pull out the small rubber plug from the air hole as above picture shown. Place 4pcs of air filters into air holes, the thicker side is down into tank.
Tear off the sticker Fix the balance arm Fix the arm on the 11.
Too long twist Perfect 7)Seventh step Instert the plug Turn on the power switch check wether all thing is usual 8)Eighth step: Nozzle check Usual Broken line The nozzle check patterns are in broken-line, mostly because of small dusk entered into the nozzle, after repeated cleaning, if there is still a few broken line, the nozzle check pattern, maybe it works well.
If the indicator light flashing when printing, it tells that you need to reset the chip to full status. Please turn off your printer for about 30 seconds and switch it back on. Ink meter bar shall show full ink. You can start printing as usual. 5、Refill Ink: Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.
5. Don’t put the continuous ink supply systems reversed or leaning during the shipment. Please make sure all the ink filling holes and Ventilation holes are closed tightly during the transportation. Otherwise, the ink shall leak out. 6. Don’t sway the cartridge frequently. It may cause ink leakage. 7. Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge. Warning: 1. Not drinkable; keep it out reach of children. 2.
