EPSON Stylus Photo EX paper support extension Accessories paper support Ink Cartridges printer cover edge guides control panel Cartridge Part number Black S020093 Color S020110 Media output tray output tray extensions ink cartridge clamp load/eject button paper out thickness light lever color ink out light black ink out light power light power button cleaning button Media name Size Part number EPSON 360 dpi Ink Jet Paper Letter A4 S041060 S041059 EPSON High Quality Ink Jet Paper
EPSON Stylus Photo EX Ink Cartridge Printer Specifications Printing Printing method EPSON’s exclusive drop-on-demand Micro Piezo™ ink jet technology Specification Black ink cartridge (S020093) Color ink cartridge (S020110) Color(s) Black Cyan, Magenta, Yellow, Light Magenta, Light Cyan Print capacity* 540 pages/A4 (ISO/IEC 10561 Letter Pattern at 360 dpi) Nozzle configuration 220 pages (A4, 360 dpi, 5% duty each color) Black 32 nozzles Cartridge life Color 32 nozzles × 5 (cyan, magenta, yell
EPSON Stylus Photo EX Paper Paper type Size Paper types Thickness Weight Single sheets Letter (8.5 × 11 inches) Legal (8.5 × 14 inches) Ledger or B size (11 × 17 inches) Statement (5.5 × 8.5 inches) Executive (7.5 × 10 inches) A3 (297 × 420 mm) A4 (210 × 297 mm) A5 (148 × 210 mm) B4 (257 × 364 mm) B5 (182 × 257 mm) Plain bond paper and special ink jet papers distributed by EPSON 0.003 to 0.004 inch (0.08 to 0.
EPSON Stylus Photo EX Printable area A A B-L B-R B-L C B-R EPSON Panoramic Photo Paper A: The minimum top margin is 0.12 inch (3.0 mm). B-L, The minimum left margin is 0.12 inch (3.0 mm). B-R: The minimum right margin is 0.54 inch (14.0 mm). C: The minimum bottom margin is 0.12 inch (3.0 mm). C single sheet Note: Always load paper into the sheet feeder short edge first. However, envelopes should be loaded long edge first. A Mechanical B-R B-L C envelope A: The minimum top margin is 0.
EPSON Stylus Photo EX Electrical Hardware initialization Specification 120 V Model 220−240 V Model* Input voltage range** 99 to 132 V 198 to 264 V Rated frequency range 50 to 60 Hz Input frequency range 49.5 to 60.5 Hz Rated current 0.4 A Power consumption Approx. 15 W (ISO/IEC 10561 Letter Pattern) Approx. 5 W in standby mode (120 V model) Approx. 5.
EPSON Stylus Photo EX Bit rate: Approx. 900Kbps Handshaking: X-ON/X-OFF and DTR protocol Word format: Data bit: 8 bits Parity bit: None Start bit: 1 bit Stop bit: 1 bit Connector 8-pin mini-DIN Recommended cable: Apple System Peripheral-8 cable (part number M0197) Control Panel paper out light load/eject button power light PSBA When the power and paper out lights flash and the ink out lights are on, your printer has a carriage error.
EPSON Stylus Photo EX 5. Pull up the two ink cartridge clamps. (The illustration shows the color ink cartridge clamp.) Caution: Never turn off the printer when the P power light is flashing. But if the light is still flashing after five minutes and the printer isn’t moving or making noise, you may turn off the printer. Testing the Printer You can run a printer check to determine whether a problem comes from the printer itself or some other source.
EPSON Stylus Photo EX Printing on Special Media When you print on special media, you need to be careful about choosing the correct Media Type and Paper Size settings in your printer software. The following table lists the available EPSON media and the corresponding Media Type setting to select in your printer software. For this media name... Load a maximum of this many sheets...
EPSON Stylus Photo EX Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Replacing an Ink Cartridge Caution: To ensure good results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty. Installing the New Cartridge Once you have removed the empty cartridge, you’re ready to install the new one.
EPSON Stylus Photo EX Replacing an Outdated Ink Cartridge Using the Head Cleaning Utility If an ink cartridge is more than six months old, you may need to replace it. How can you tell? You may notice that your printouts don’t look as good as they used to. If print quality doesn’t improve after cleaning and aligning the print head, you may need to replace one or both cartridges.
EPSON Stylus Photo EX Examining the Nozzle Check Pattern 3. Clean the exterior of the printer with a soft, damp cloth. Keep the printer cover closed so water doesn’t get inside. Examine the nozzle check pattern after printing it. It should look something like this, with each of the six sections showing one of the ink colors: 4. Clean ink out of the printer’s interior with a damp cloth. Caution: Don’t use the cleaning sheets that may be included with your special media; they may damage the printer.
EPSON Stylus Photo EX 12 - EPSON Stylus Photo EX 3/98
