Network Guide

Tips for Administrator 41
Chapter 5
Tips for Administrator
Network Setup Menu
These items are used to make network settings on the printer’s control panel.
* Available only when Enable is selected for NETWORK SETUP.
Setting an IP Address Using the arp/ping Command
Follow the steps below to set the IP address using the arp/ping command.
Note:
❏ Make sure that the Set using PING function is enabled on the TCP/IP menu in EpsonNet
Config. If this function is disabled, you cannot set the IP address using the arp/ping command.
❏ Make sure the network interface and the computer are in the same segment.
Before you start, you need the following information:
❏ A valid IP address for the network interface. Ask your network administrator for an
IP address which does not cause conflicts with any other device on the network. If
you are the network administrator, choose an address within your subnet which does
not conflict with any other device.
❏ The MAC (Ethernet hardware) address of the network interface. You can find out the
MAC address on a status sheet.
Item Settings (default in bold)
NETWORK SETUP Disable, Enable
IP ADDRESS SETTING* Auto, Panel
IP* 0.0.0.0 to 255.255.255.255
SM* 0.0.0.0 to 255.255.255.255
DG or GW* 0.0.0.0 to 255.255.255.255
Bonjour* On, Off
INIT NETWORK
SETTING*
EXECUTE