Operation Manual

Removing the spacer
A
Remove the black flange from the spindle.
B
Remove the spacer.
Hold the outer edge of the spacer and pull it
straight off.
Placing roll paper on the spindle
Follow the steps below to set roll paper on the spindle
supplied with this printer.
A
Remove the black flange from the spindle.
B
Insert the spindle into the roll paper.
Place the roll paper on a flat surface where the end
of the roll paper is hanging down towards you,
and insert the spindle from the right.
C
Install the black flange.
Push till there are no gaps between the roll paper
and both flanges.
Loading roll paper
Follow the steps below to load roll paper on the printer.
Note:
Insert the paper just before printing. If the paper is left in
the printer, the roller of the paper presser may leave a
mark on the surface of the paper.
A
Make sure the printer is on.
B
Check the paper source settings.
Check the paper source icon on the screen, and if
it differs from the paper that you want to load,
change the setting.
: Prints on roll paper and cuts
automatically after printing each
page.
: Prints on roll paper but does not cut
after printing.
: Prints on cut sheets.
To change the setting, press the l button. When
the Paper Type menu is displayed on the screen,
select Roll Paper / Cut or Roll Paper / No Cut,
and then press the Z button.
C
Open the roll paper cover.
Epson Stylus Pro 4900/4910 User's Guide
Basic Operations
29