Operation Manual

D
Set the edge guide according to the width of the
paper you want to load.
E
Insert the paper into the rear manual feeder with
the printable side face up as shown in the
illustration.
Insert the paper until it reaches the bottom.
F
Check that the leading edge of the paper is
inserted as far as the gray roller inside the printer.
Press the d button to feed the paper.
G
Slide out the output tray to the second and third
extensions.
Do not raise the flap. If the flap is raised while
printing, the paper may not be ejected correctly.
Note:
Remove each sheet of paper as it is ejected without
letting the sheets stack up on the output tray.
Tip:
Except when installing the optional
SpectroProofer, check that the paper eject support is
lowered. If the paper eject support is raised, lower it
before printing.
Loading and Ejecting Thick
Paper
Note:
When the optional SpectroProofer is installed, you
cannot print from the front manual feeder.
How to load
A
Make sure the printer is on.
Epson Stylus Pro 4900/4910 User's Guide
Basic Operations
40