Installation Instructions

6. Slide the interface card along the slots on both sides of the

interface compartment. Push it in firmly to fully insert the

connector at the rear of the interface card into the printer’s

internal socket.

7. Secure the interface card in the slot with the two screws

included with the interface card.

8. Connect a compatible interface cable to the interface card and

to your computer. If the cable has a grounding wire, secure

it with one of the screws.

Also, if you are using more than one computer, reconnect the

other interface cable.

9. Make sure the printer is turned off. Then plug in the power

cord.

To remove an interface card, follow the above steps in reverse

order.

k-25

K-26

Keywest Setup Guide

Rev.c

A5 size Chapter 4

10-09-97 DR, pass 3

Installing Options and Memory Modules

4-9