Operation Manual

The Control Panel 194
1. Enter Maintenance mode.
Make sure that the printer is turned off. While pressing and
holding the Pause
button, press the Power button to
turn on the printer.
2. Select an item.
Press the Paper Feed d button or Paper Feed u button to
select a desired item.
3. Set the item.
Press the Menu r
button to enter the selected item. The first
parameter is displayed on the LCD panel.
4. Select a parameter.
Press the Paper Feed d button or Paper Feed u button to
select a parameter for the item.
5. Set the parameter.
Press the Enter
button to store the selected parameter.
If the parameter is used for execution only, press the Enter
button to execute the function for the item.
Note:
If a second parameter is displayed on the LCD panel, repeat steps 4
and 5 to select and set the second parameter.
6. Exit Maintenance mode.
Press the Power
button to turn off the printer, and then
turn it on again.