Operation Manual

74
9. After the printing, THICKNESS NUM is printed on the upper side
and the numeric data is printed on the lower side. Select the
noted number in step 8 using the Paper Feed (
u) or Paper
Feed (
d) button.
Note:
The default value depends on the PAPER THKNS. value in the
Head Alignment menu and is displayed as a THICKNESS NUM
in the Paper Configuration menu as shown below:
10. Press the Enter button to save the selected value.
11. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display CUT PRESSURE. Press the SelecType
button (
r) and Paper Feed ( u) or Paper Feed ( d) button to
set the cutter pressure for cutting paper, then the Enter button.
12. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display CUT METHOD. Press the SelecType button
(
r) and Paper Feed ( u) or Paper Feed ( d) button to select
either 3STEP or 4STEP, then the Enter button. When cutting
non-EPSON media and weaker or thicker paper, 4STEP is
recommended.
13. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display PPR FEED ADJ. Press the SelecType ( r)
button and Paper Feed (
u) or Paper Feed ( d) button to set
the paper feed amount, then the Enter button.
14. Press the Paper Source (
l) button and then the Paper Feed
(
d) button to display DRYING TIME. Press the SelecType ( r)
button and Paper Feed (
u) or Paper Feed ( d) button to set
the drying time in seconds, then the Enter button.
PAPER THKNS. value THICKNESS NUM
0.0 MM
to
1.6 MM
1
to
17