user manual
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up the Printer
- Unpacking and Assembling the Epson Stylus Pro 7800
- Unpacking and Assembling the Epson Stylus Pro 9800
- Connecting the Power Cord
- Installing Ink
- Connecting to Your System
- Connecting to the Network
- Installing the Software for Macintosh
- Installing the Software for Windows
- Updating Your Printer Firmware
- Configuring the Printer for Your Network
- Chap 2-Handling Paper and Other Media
- Chap 3-Printing with Epson Drivers for Macintosh
- Chap 4-Printing with Epson Drivers for Windows
- Chap 5-Maintaining and Transporting the Printer
- Checking Printer Status and Part Life
- Checking and Cleaning the Print Head
- Aligning the Print Head
- Replacing Ink Cartridges
- Switching Black Ink Cartridges
- Changing the Date and Time
- Using Maintenance Mode
- Replacing the Paper Cutter Blade
- Replacing the Maintenance Tank
- Cleaning the Printer
- Transporting or Storing the Printer
- Chap 6-Solving Problems
- Appendix A: Specifications
- Index
5-133
Maintaining and Transporting the Printer | 133
5. Press the button.
6. Follow the instructions on the LCD display to raise the ink levers.
7. When
REMOVE ALL FOUR INK CARTRIDGES ON THE RIGHT
SIDE
appears, remove all four ink cartridges from the right ink
compartment.
8. When
INSTALL C/M/Y CONVERSION CARTRIDGES appears, insert
the three conversion cartridges in the slots on the right ink
compartment.
Note: If REPLACE
CONVERSION CRTG
appears, press the
Pause button.
Remove the old
conversion cartridge(s)
from the right ink
compartment, and then
insert the new
conversion cartridge(s).
Go to step 4 to start
again.
7800-9800Guide.book Page 133 Monday, April 10, 2006 11:59 AM