user manual
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up the Printer
- Unpacking and Assembling the Epson Stylus Pro 7800
- Unpacking and Assembling the Epson Stylus Pro 9800
- Connecting the Power Cord
- Installing Ink
- Connecting to Your System
- Connecting to the Network
- Installing the Software for Macintosh
- Installing the Software for Windows
- Updating Your Printer Firmware
- Configuring the Printer for Your Network
- Chap 2-Handling Paper and Other Media
- Chap 3-Printing with Epson Drivers for Macintosh
- Chap 4-Printing with Epson Drivers for Windows
- Chap 5-Maintaining and Transporting the Printer
- Checking Printer Status and Part Life
- Checking and Cleaning the Print Head
- Aligning the Print Head
- Replacing Ink Cartridges
- Switching Black Ink Cartridges
- Changing the Date and Time
- Using Maintenance Mode
- Replacing the Paper Cutter Blade
- Replacing the Maintenance Tank
- Cleaning the Printer
- Transporting or Storing the Printer
- Chap 6-Solving Problems
- Appendix A: Specifications
- Index
2-72
72 | Handling Paper and Other Media
If the basket is loose, tighten it as shown:
Catching Printouts in Front of the Epson Stylus Pro 9800
Follow the steps below to set up the basket in front of the printer. Use this
method for posterboard or any prints that are 62 inches or more in length.
1. If you are using the paper guides, make sure they are in front of the
basket, as shown below.
2. Slide the upper metal rods all the way in. Then push the lower rods
down, so that they rest on the floor.
7800-9800Guide.book Page 72 Monday, April 10, 2006 11:59 AM