Operation Manual

Epson Stylus Pro 7900/7910/9900/9910 User’s Guide
The Control Panel
21
Details of Menu mode
PRINTER SETUP
Item Parameter Explanation
PLATEN GAP NARROW You can adjust the distance between the print head and paper.
O STANDARD: Normally, select STANDARD.
O When selecting other than STANDARD, the following icon
appears on the LCD panel.
: NARROW
: WIDE
: WIDER
: WIDEST
STANDARD
WIDE
WIDER
WIDEST
PAGE LINE ON You can select whether to print a page line (line along which to
cut) on the roll paper. Select ON if you want to print the page line,
or OFF otherwise.
The vertical line may be printed when the roll paper width that is
set in the printer driver is smaller than the width of the roll paper
that is loaded in the printer.
This setting is available for roll paper only.
OFF
ROLL PAPER MARGIN DEFAULT You can select margins for roll paper.
O DEFAULT:
The top margin of Premium Glossy Photo Paper (250),
Premium Semigloss Photo Paper (250), and Premium Luster
Photo Paper (260) are 20 mm and the bottom margin is 15
mm.
O TOP/BOTTOM 15mm:
The top and bottom margins are 15 mm and left and right
margins are 3 mm.
O TOP 35/BOTTOM 15mm:
The top margin is 35 mm, bottom is 15 mm, and left and
right are 3 mm.
O 15mm:
The margins of all four sides are 15 mm.
O 3mm:
The margins of all four sides are 3 mm.
The print size does not change even when the margins are
changed.
TOP/BOTTOM15mm
TOP 35/BOTTOM 15mm
15mm
3mm
PAPER SIZE CHECK ON You can select whether to check the paper width.
O ON:
Check the paper width and top edge of the paper.
O OFF:
Do not check the paper width and top edge of the paper.
The printer continues to print even if the paper width does
not match the data width, and the printer may print beyond
the paper. Because this soils the inside of the printer, we
recommend you select ON. This may result in a wider blank
margin at the top of each page.
OFF