Operation Manual

Epson Stylus Pro 7900/7910/9900/9910 User’s Guide
Paper Handling
50
Taking up your prints
When the Auto Take-up Reel Unit is installed, and the
take-up reel core is loaded with paper to take up in the
desired direction, you can use the unit to take up your
prints.
A
Set the Auto switch to Forward or Backward.
B
Send a print job to the printer.
The printer starts printing. The Auto Take-up
Reel Unit takes up the roll paper in the direction
you set in step 1.
Removing paper after take-up
After paper take-up, follow the steps below to remove
the take-up reel core.
A
Set the Auto switch to Off.
B
Cut the roll paper.
O Press the button to cut the roll paper.
O If the roll paper cannot be cut with the
built-in cutter, use a scissors or cutter sold
at a store.
C
Turn the lever to unlock the movable unit, and
then slide it to the left so that the flange knob
clears the end of the take-up reel core.
While doing this, support the take-up reel core
with one hand to keep it from falling.
w
Warning:
Do not touch the Auto Take-up Reel Unit while it
is operating. Doing so may result in injury.
Note:
When printing by using the Roll Auto Cut On ,
set the Auto switch of the Auto Take-Up Reel Unit to
Off, otherwise the printer does not cut the paper. You
can set the Auto switch to Off during printing to cut
the paper automatically.