Operation Manual

Epson Stylus Pro 7900/7910/9900/9910 User’s Guide
Problem Solver
96
Error messages related to the options
Error messages Description What to do
TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL SYSTEM IN
PRINTER AND RESTART THE
PRINTER
Auto Take-up Reel Unit is
not correctly installed in the
printer.
Turn the printer off, and then install the Auto Take-up
Reel Unit properly.
See “Using Auto Take-up Reel Unit (For Epson
Stylus Pro 9900/9910 only)” on page 47
TAKE-UP DISCONNECTED
AUTO TAKE-UP REEL UNIT IS
DISCONNECTED
DO YOU CONTINUE?
NO
YES
Auto Take-up Reel Unit is
not correctly installed in the
printer.
Select NO, and turn the printer off, and then install the
Auto Take-up Reel Unit properly. If you select YES, the
paper is ejected without using the Auto Take-up Reel
Unit.
See “Using Auto Take-up Reel Unit (For Epson
Stylus Pro 9900/9910 only)” on page 47
TAKE-UP ERROR
CHECK THE STATUS OF AUTO
TAKE-UP REEL UNIT AND RESTART
THE PRINTER
The roll paper is not set to
the Auto Take-up Reel Unit
properly.
Press the button to release the paper presser, and
then set the roll paper to the Auto Take-up Reel Unit
properly.
See “Using Auto Take-up Reel Unit (For Epson
Stylus Pro 9900/9910 only)” on page 47
TAKE-UP ERROR
IS ANYTHING OBSTRUCTING THE
TAKE-UP REEL SENSOR SYSTEM?
LOAD PAPER AGAIN
The Auto Take-up Reel Unit
does not wind the paper.
Make sure there is no obstruction in the sensor system.
Press the button to release the paper presser, and
then set the paper correctly in the Auto Take-up Reel
Unit.
See “Using Auto Take-up Reel Unit (For Epson
Stylus Pro 9900/9910 only)” on page 47
SProofer DISCONNECTED
CONNECT SpectroProofer
TO THE PRINTER
AND RESTART THE PRINTER
The SpectroProofer is not
connected to the printer
properly.
Turn the printer off, and then connect the
SpectroProofer to the printer properly.
See the SpectroProofer Mounter 24"/44" Setup Guide
ILS20EP DISCONNECTED
REFER TO THE MANUAL AND
CONNECT ILS20EP TO
SpectroProofer
RESTART THE PRINTER
The color measurement
device (ILS20EP) is not
connected properly.
Turn the printer off, and then connect the color
measurement device (ILS20EP) to the SpectroProofer
properly.
See the SpectroProofer Mounter 24"/44" Setup Guide