Service manual

4.1.3 Black Head Angle Adjustment
The black head angle adjustment is required when the black head is replaced or disassembled. If this
adjustment is not correct, a white banding problem may occur, or color head timing may not match black
head timing. The following figure illustrates the black head angle adjustment. The black head angle is
adjusted with linear and angular spacers. A linear spacer is attached to both sides of the head base, and an
angular spacer is attached only to the right side of the head base. Spacers for the black head come in different
shapes for the thickness needed. The following figure shows the relationship between the shape and thickness.
Black Head
(Angle Adjustment)
Head Base
Head Carriage
Angular Spacer
Linear Spacer
Figure 4-2. Black Head Angle Adjustment
Angular Spacers (for Black Head)
angular spacer BK
Spacer Name Thickness Shape
0.05
0.10angular spacer BK-B
angular spacer BK-C
angular spacer BK-D
angular spacer BK-E
0.15
0.20
0.25
linear spacer K
Spacer Name Thickness Shape
0.05
0.12
0.19
0.26
0.33
Linear Spacers (Only for Black Head)
0.47
0.54
0.61
0.68
0.75
0.40
linear spacer J
linear spacer I
linear spacer
linear spacer B
linear spacer C
linear spacer D
linear spacer E
linear spacer F
linear spacer G
linear spacer H
Figure 4-3. Types of Spacers and Relationship between
Shape and Thickness
Stylus Pro XL+ Service Manual Adjustment
Rev.A 4-5