Service manual

11. Replace the angular spacer for the black head with a new one. (Refer to Figure 4-7.)

(To replace the angular spacer, use tweezers to push the head base toward the rear.)

12. After replacing the angular spacer, reassemble the ink cartridge holder and reinstall the ink cartridges.

Use the BASIC program to verify the angle of the black head. Confirm the angle by performing the

steps 1 to 6 again, and if the angle is wrong, perform the adjustment again until the head angle is correct.

❏ The angular spacers come in five thicknesses. Continue performing this adjustment by

changing the black head spacers until the angle is correct.

❏ When inserting an angular spacer, always place the angular spacer on the linear spacer.

CBB(M3x11)

Color Ink Cartridge Holder

Rubber Cap

CBB(M3x11)

Figure 4-6. Removing the Rubber Cap

1. Push

Head Base

Linear Spacers

Platen Gap Adjust Lever

Angular Spacer

Carriage Unit

Black Head

2. Replace

Figure 4-7. Angular Spacer Replacement Method

Adjustment Stylus Pro XL+ Service Manual

4-8 Rev.A