Service manual

4.1.4 Color Head Angle Adjustment

The color head angle adjustment is required when the color head is replaced or disassembled. If this

adjustment is not correct, a white banding problem may occur, or the black head timing may not match the

color head timing. The following figure illustrates the color head angle adjustment. The color head angle is

adjusted with the angular spacer. The angular spacer is attached only to the left side of the head base.

1. Connect the PC to the target printer using a parallel interface cable and turn the printer on.

2. Load BASIC on the PC, and run the program. You see the following destination select menu.

***** Customer *****

1. EAI, EAI (Latin America), EAL, ESP

2. EDG, EUL, EFS, EIS, EIB, EUL (Northern Europe), EUL (Middle East), EHK

4. JAPAN

7. END

Select Menu ?

3. Input the number for the destination. Then the main menu appears, as shown below.

If you enter an incorrect number as the destination selection, printer functions are not

guaranteed.

STYLUS Pro XL+ Program : Rev. X

customer :

1. Head VH input

2. Ink consumption counter reset

3. Head angular & linear adjustment

4. Head position check

5. BK. YMC head gap adjustment (head gap center )

6. Bi-D adjustment (Bi-d center )

7. Head VH indication

10. Change customer & data / END

0. Cleaning

Select Menu ? ■

Color Head

(Reverse Side)

Head Base

(Angle Adjustment Concept)

(Spacer Setting Location)

Carriage

Angular Spacer

Figure 4-8. Color Head Angle and Angular Spacer Position

Stylus Pro XL+ Service Manual Adjustment

Rev.A 4-9