Service manual

7. Move the carriage to the center manually, and loosen (but do not remove) the screw securing the color
head to the carriage.
8. Remove the rubber cap covering the head screw at one side of color ink cartridge. Then loosen (but do
not remove) 3 screws. (Refer to the Figure 4-9.)
9. Replace the angular spacer on the left side with a new one, referring to the figure below. (Replace the
angular spacer using tweezers to push the head base toward the rear.)
10. Rerun the BASIC program and choose “3, Head Angle Confirmation Pattern Printing” again by typing 3
and pressing ENTER. Then verify that the confirmation sample is correct.
11. If the sample is incorrect, repeat steps 6-10 until the upper lines in the sample are aligned with one
another and the lower lines in the sample are exactly equidistant to one another (as shown at B in Figure
4-11).
12. When you complete this adjustment, turn off the printer.
Position A, B Position A, B
Replace the right
angular spacer
with a thicker one
Replace the right
angular spacer
with a thinner one
(A) (B) (A) (B)
Look at
positions A, B
Figure 4-11. Spacer Selection
1
2
Carriage Unit
Base Head
Paper Gap Adjust Lever
Spacer Angular
(one side only)
Color Head
Push
Replace
Figure 4-12. YMC Angular Spacer Replacement
Stylus Pro XL+ Service Manual Adjustment
Rev.A 4-11