Service manual

9. Change the linear spacers (2 spacers for the monochrome head only) with new ones, referring to the
figure below. (Replace linear spacers by using tweezers to push the head base toward the rear.)
10. Rerun the BASIC program, and choose the “Head Vertical Position Confirmation” by typing 3 and
pressing ENTER; then confirm that the sample print is correct. If the sample is incorrect, change the
thickness of the linear spacer and perform this adjustment again until the two black and magenta lines
are aligned at the position “OK (0)."”
11. When you complete this adjustment, exit the BASIC program and turn off the printer.
2
Push
Carriage Unit
Linear Spacers x 2
Head Base
Platen Gap Adjust Lever
(Linear Spacer Replacement Position)
Angular Spacer
Replace
1
Figure 4-15. Linear Spacer Replacement Method
Adjustment Stylus Pro XL+ Service Manual
4-14 Rev.A