Service manual

5. If the sample print is not vertically aligned for both the odd-numbered and even-numbered lines, enter a
compensation value in the range from –30 to +30.
❏ Positive compensation value: Shifts the 2nd line to the left
❏ Negative compensation value: Shifts the 2nd line to the right
When the sample print becomes vertically aligned for both lines, press Y and ENTER; then the printer
prints out the current Bi- D setting pattern, and this returns you to the 360 DPI Bi-d adjustment mode.
6. Adjust the 360 DPI Bi-d setting mode in the same way as 720 dpi Bi-D adjustment.
7. If you have finished the 360 dpi Bi-d adjustment, choose “10, END” by typing 10 and pressing
ENTER. (The destination setting menu appears on the display again.)
8. Choose “7, END” by typing 7 and pressing ENTER to quit the adjustment program.
Settings have not been written to the EEPROM yet. Turn off the printer immediately after the
adjustments.
9. Turn off the printer.
Adjustment Stylus Pro XL+ Service Manual
4-18 Rev.A