Operation Manual

12-16 Troubleshooting
After trying one or more of these solutions, run a printing
operation check to see whether the problem has been solved. See
“Running a printer operation check” on page 12-4.
Printing is too slow
Try one or more of these solutions.
❏ Make sure the Media Type setting is set correctly in your
printer driver. For instructions, see “Making the Media Type
setting” on page 4-5 for Windows or “Making the Media Type
settings” on page 6-4 for Macintosh.
❏ To increase speed, select the Automatic mode and then set
the slide bar to the Speed setting. For instructions, see “Using
the Automatic setting” on page 4-7 for Windows or “Using
the Automatic setting” on page 6-5 for Macintosh.
❏ Don’t run too many applications at the same time. Close any
applications you are not using at the moment.
❏ Delete unnecessary files to make room on your hard disk
drive.
Note:
Your computer may not have enough memory. For further tips, See
“Increasing the Print Speed” on page 4-30.
❏ If you upgraded from Windows 95 to Windows 98, uninstall
the EPSON Stylus Scan software using Add/Remove
Programs in Windows, then install the software again.
Scanning Problem
Note:
When the Stylus Scan is connected through the parallel interface under
Windows, it will be impossible to use the scanner if the printer driver is
uninstalled.