User Guide

EPSON Stylus Scan 2500 Revision A
Product Description Control Panel 27
1.6.3 Initialization
PRINTER INITIALIZATION
There are three initialization methods.
1. Power-on (hardware) initialization
The printer initializes when turned on or when it recognizes the cold-reset
command (remote RS command).
When the printer initializes, the following actions are performed.
Initialize printer mechanism
Clear input data buffer
Clear print buffer
Set default values
2. Operator initialization
The printer initializes when turned on within ten seconds of being turned
off, or when the printer recognizes the -INIT signal (negative pulse) from
the parallel interface.
When the printer initializes, the following actions are performed.
Cap the printhead
Eject paper
Clear input data buffer
Clear print buffer
Set default values
3. Software initialization
The ESC@ command also initializes the printer.
When the printer initializes, the following actions are performed.
Clear print buffer
Set default values
Table 1-15. Initialization
Operation
Operat
ing
Stand
by
Controller
process
Scanner
process
Printer
process
Restart
Power on Valid Valid
Set the local
copy setting to
default
H/W
initialization
H/W
initialization
-
Panel
Reset
Valid Valid
Controller
initialization
Panel
initialization
-
Initialize
by
command
Valid Valid
S/W
initialization
S/W
initialization
-
STOP Valid -
• Stop
copying
•Setting
remains as
is
Cancel Eject paper
Copy
button
CLEAR - Valid
•Setting
mode:
default
• Copy mode:
Multi-copies
volume 1