Technical information

17
Sawgrass Technologies, Inc. ~ Epson
®
WorkForce 30/T30/B40W ~ ChromaBlast™
PRINTING AND HEAT TRANSFER INSTRUCTIONS
RECOMMENDED APPLICATIONS
White or light-colored fabrics in 100% cotton.
PRINTING
Print using the supplied ChromaBlast Driver program only. The print side of ChromaBlast
Media is opposite the ChromaBlast logo. For the Epson WF30, place print side face up in
the printer tray. Mirror Image: Check this box in the ChromaBlast Driver to ensure the
image prints in reverse and that text appears correctly when image is transferred. If your
image is already reversed in your graphic program, leave this box unchecked.
TRANSFERRING THE IMAGE USING A COMMERCIAL HEAT PRESS
1. If desired, you may trim the non-printed area before transferring, leaving .25 in.
margin around the printed area.
2. Place garment on the heat press. Cover with ChromaBlast paper with image face
down.
3. Press image according to proper pressure, heat, and time settings.
4. Peel the paper off the shirt while the shirt is still hot using an even motion.
5. Stretch the image area while the shirt is hot from both left to right and top to bottom
to reduce the hand.
HEAT PRESS SETTINGS
Pressure: Heavy. If using a pneumatic press, set the pressure to 60 psi.
Temperature and Time: 350°F (176°C) for 45-60 seconds.
Due to variations in cotton garments and in heat presses, time and temperature can be
adjusted for preferred performance up to 400°F for 25 seconds. Some scorching may
occur, but will wash out.
STORAGE INSTRUCTIONS
Store ChromaBlast Media in a cool, dry area within the provided plastic storage bag.
Do not remove from carton until ready to use.