Installation manual

3-12 Utilities Rev. F
6. Check the print result. If correction is required, enter a new top margin position and then
click [Retry]. Another test page is printed by using the new top margin position, and the
same message appears. Repeat these steps until the correct top margin is obtained.
7. After the top margin correction value is determined, click [Save and Exit]. The top margin
correction value is saved and correction is completed.
Printing
direction
Check the number appearing at the top
of the fan object. Enter this number. In this
example, entering -6 will correct the
problem and the top margin will be
printed in the correct position, as shown
in the figure on the right.
<Print result example: where top margin correction is required>
<Print result example: where top margin position is correct>
The number at the top
edge of paper is 0.