Installation manual

3-14 Utilities Rev. F
6. Check patterns #1 and #2 in the print result. If correction is required, enter the new position
correction values and then click [Retry]. The two patterns are printed again, and the same
message appears. Repeat these steps until the correct right margin is obtained.
7. After the right margin correction value is determined, click [Save and Exit]. The right margin
correction value is saved and correction is completed.
Printing
direction
Check the number
appearing at the right
side of the fan object.
Enter this number. In this
example, entering -2 will
correct the problem and
the right margin will be
printed in the correct
position, as shown in the
figure on the right.
<Print result example: where right margin
correction is required>
The number at the right
edge of paper is 0.
<Print result example: where right margin
position is correct>