Specifications

214
Setup Procedure
The setup procedure from the printer installation to ready-to-print status is described below.
1
Install the printer. (page 61)
2
Connect the power supply unit. (page 62)
3
Load the roll paper included in the package in the printer. (page 81)
4
For Ethernet interface model, connect the printer to the network. (page
66)
5
Load the ink cartridge. (page 63)
Turn on the printer before loading the ink cartridge.
It t akes about 8 minutes for ink charging. When ink charging finishes, the POWER LED
stops flashing and stays on.
6
For the Ethernet interface model, make the network settings such as IP
address to the printer with EpsonNet Config.
7
For the USB interface model, connect the printer to the client computer.
(page 65)
Turn off the printer before connecting it to the client computer.
8
Install the printer driver (the install package) on the client computer, and
make the settings for it.
9
For the USB interface model, install the Printer Setting to the client com-
puter.
10
Make the settings for the printer with the Printer Setting.
11
Set the DIP switches of the printer. (page 74)
Turn off the printer before setting the DIP switches.
12
Load the paper. (page 76)
Set the paper according to the DIP switch setting.
13
Perform a test print.