Specifications

5-14 Installation, Printer Handling, Removing a Paper Jam
Confidential
Notes on check sheet handling
❏
When insert a check for MICR reading or endorsement, insert the check as shown, with the
side with the MICR characters facing up and with the MICR characters on the right side and
the check against the right side of the paper guide.
❏
The printer will detect the check and start drawing it in. When the printer starts drawing it
in, let go of the check immediately. When the printer ejects the check and the SLIP light
starts blinking again; remove the check by pulling it straight up; do not pull it at an angle.
❏
Checks are ejected in the forward direction only (the default is the forward direction).
❏
The check insertion waiting state is canceled using
DLE ENQ 3
.
❏
After the personal check is ejected, the SLIP LED lights, and the printer does not proceed to
the next operation until the check is removed.
❏
The check waiting time and the interval from when a check is inserted to when the operation
starts can be set using
ESC f
.
❏
To check the MICR function status, use
DLE EOT BS 1
.
Notes on using the MICR Reader
Do not install the printer near any magnetic fields. Be especially careful where you install your
display device and be sure to check the recognition rate of the MICR reader with the display
device in place.
Make sure that the printer is not subjected to any impact or vibration when it is performing a
MICR reading.
4Transmit
GS ( G 2 0 84 1
Select the print starting position on the back side of
the check.
5 Transmit endorsement printing data Prints data and feeds paper.
6Transmit
FF
After printing, ejects paper.
The SLIP LED blinks until the check is removed.
7 Eject the check paper The SLIP LED is off.
User Operation Printer Operation
MICR
characters on
this side, face
up