Specifications

General Information 1-11

TM-H6000/H6000P Developer’s Guide

Confidential

3. Set switches using a pointed tool, such as tweezers or a small screwdriver.

4. Replace the DIP switch cover. Then secure it with the screw.

The new settings take effect when you turn on the printer.

Memory Switches

Function 3 of the

GS ( E

command changes bits of the memory switch 1 or 8 to ON or OFF as

shown in the table below (default: OFF):

• Switch 1

• Switch 8

Note:

Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the

settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do

not use this function more than 10 times a day.

Bit ON OFF

1 Transmits the power ON notice Does not transmit the power ON notice

2 ~8 Reserved (Do not change the setting)

Bit ON OFF

1-2 Reserved (Do not change the setting)

3 Uses a 58 mm width roll paper Uses an 80 mm width roll paper

4-7 Reserved (Do not change the setting)

Becomes recoverable error if the unit cover is open

during printing

Becomes offline if the unit cover is

open during printing

switches