Specifications

General Information 1-13
TM-H6000/H6000P Developer’s Guide
Confidential
See Chapter 5 for removing a paper jam.
Note:
When the printer recovers from an error using DLE ENQ 1 while slip paper is selected, the printer first
ejects the slip, then loads paper. However, when the printer recovers from a slip ejection error, the printer
only ejects the slip and does not load paper.
When the printer recovers from an error using DLE ENQ 2 while slip paper is selected, the printer ejects
the slip.
❏
Errors that are impossible to recover:
Data Receive Error
If one of the following errors occurs during serial interface communication, the printer prints “?”
or ignores the data, depending on the setting of DIP switch 1-1.
❏
Parity error
❏
Framing error
❏
Overrun error
ERROR Description
ERROR LED Blinking Pattern
Recovery
R/W error in memory
or gate array
After R/W checking, the
printer does not work
correctly
Impossible to recover
High voltage error The power supply voltage
is extremely high
Impossible to recover
Low voltage error The power supply voltage
is extremely low
Impossible to recover
CPU execution error The CPU executes an
incorrect address or I/F
board is not connected
Impossible to recover
Control circuit board
error
There is an abnormality in
the print head
temperature, thermistor is
detected incorrectly or
thermistor wiring is not
connected or the
endorsement printer is
broken, or the lever driving
motor is broken
Impossible to recover
320 ms