Specifications

Hardware 2-9
TM-H6000/H6000P Developer’s Guide
Confidential
Character Specifications
• Space between characters is not included.
• Characters can be scaled up to 64 times the standard sizes.
• When using Font B with a font mode such as emphasized, some words may be hard to read. Check the font
mode in advance when using Font B.
CPL = Characters per line
Autocutter
Partial cut: Cutting with one point left uncut
NOTES:
1. To prevent dot displacement, after cutting, feed paper approximately 1 mm (14/360 inches) or more
before printing.
2. If the printer is stopped, you must feed paper over 40 mm (1.58 in.) before cutting
Characters per line (default): Font A: 42
Font B: 56
Character spacing (default): Font A: 0.28 mm (.01") (2 dots)
Font B: 0.28 mm (.01") (2 dots)
Programmable by control command.
Printing speed: 44 lines/second maximum
(when the line spacing is set to 3.18 mm {1/8 inch})
(at 24V, 31°C (87.8°F), density level 2) 140 mm/second
maximum (5.5 inches/second maximum)
Speeds are switched automatically, depending on the voltage
applied to the printer and head temperature conditions.
Paper feed speed: Approximately 140 mm/second
(approximately 5.5 inches/second)
(continuous paper feeding)
Line spacing (default): 4.23 mm (1/6 inch)
Programmable by control command.
Number of characters: Alphanumeric characters: 95
Extended graphics: 128
×
11 pages (including one space page)
International characters: 37
Character structure: Font A: 12
×
24 (including 2-dot spacing horizontally)
Font B: 9
×
17 (including 2-dot spacing horizontally)
Character sizes
Standard Double-height Double-width
Double-width/
Double-height
W
×
H
(mm) CPL
W
×
H
(mm) CPL
W
×
H
(mm) CPL W
×
H (mm) CPL
Font A 12
×
24 1.41
×
3.39 42 1.41
×
6.77 42 2.82
×
3.39 21 2.82
×
6.77 21
Font B 9
×
17 0.99
×
2.40 56 0.99
×
4.80 56 1.98
×
2.40 28 1.98
×
4.80 28