Specifications

Hardware 2-37
TM-H6000/H6000P Developer’s Guide
Confidential
Drawer kick-out drive signal output waveform
4. Drawer open/close signal
Input signal level (connector pin 3): “L” = 0 to 0.8 V
“H” = 2 to 5 V
Drawer circuitry
NOTES:
1. Two driver transistors cannot be energized simultaneously.
2. The driver must not be energized continuously.
3. Be sure to use the printer power supply (connector pin 4) for the drawer power source.
4. The resistance of the drawer kick-out solenoid must not be less than the specified resistance. Otherwise, an
overcurrent could damage the solenoid.
5. The drawer kick-out power (+24V) is supplied only when the drawer is driven.
t 1x 2 msec
t 1x 2 msec
t1
x 2 msec
t2
x 2 msec
Drawer kick-out connector
1
2
3
4
5
6
F. G
P-GND
P-GND
A
B
Printer side User side (Drawer kick-out side)
+24V
With shielded
Drawer kick-out solenoid
Drawer open/close switch
With shielding
FG