Specifications

4-22 Programming Guide/Tips
Confidential
Slip Printing in Page Mode
The TM-H6000 printer can print on the front surface of slips in page mode.
The maximum number of dots in the horizontal direction is 540 half dots. When the initial value
for the basic pitch is 160, the maximum values for
d
x 1 and
d
x 2 are 28 and 2, respectively,
which are specified by the
ESC W
command.
In addition, you cannot specify the following values for bit image printing.
❏
Double-density specification with
ESC
✻
command (
m
= 1)
❏
Normal mode specification for printing of a downloaded bit image or NV bit image
❏
Normal mode (
m
= 0) or double vertical mode (
m
= 2) for raster bit images
ESC T (Selection of Character Printing Direction in Page Mode)
You can select the starting point of the printing direction in the page mode for printing on a
paper roll or slip paper (front). The respective printing direction parameters are as follows:
ESC T 0
(0 or 48) (top left to right)
ESC T 1
(1 or 49) (upward from bottom left)
ESC T 2
(2 or 50) (down from top right)