Specifications
Table Of Contents
- Confidentiality Agreement
- Chapter 1 - Specifications
- Chapter 2 - Outline of Operation
- M-J8000 printer mechanism
- Print mechanism
- Roll paper feed mechanism
- Slip feed mechanism
- Detector mechanisms
- Home-position detector mechanism
- Carriage detector mechanism
- Pump position detector mechanism
- Ink nearend detector mechanism
- Cartridge detector mechanism
- T.O.F. detector mechanism
- Paper-width detector
- B.O.F. detector mechanism
- Slip detector mechanism
- Shutter detector mechanism
- Roll paper detector mechanism
- Roll paper nearend detector mechanism
- Cover-open detector mechanism
- Cutter detector mechanism
- Autocutter mechanism
- Ink system mechanism
- Overview of electrical circuit
- M-J8000 printer mechanism
- Chapter 3 - Handling
- Chapter 4 - Maintenance and Inspection
- Chapter 5 - Repair and Troubleshooting
- Chapter 6 - Disassembly, Assembly, and Adjustment
Rev. A Disassembly, Assembly, and Adjustment 6-5
TM-J8000/J8000P Technical Manual
Confidential
Disassembly and Assembly for the TM-J8000/J8000P
Covers and upper case
Cover, carriage assembly
Follow the steps below to disassemble the parts.
1. Open the
Cover, carriage assembly
, using the tabs on both sides of it. When you open the
cover, pull it toward you a little, as shown below, then lift it up.
Figure 6-1 Open the Cover, carriage assembly
2. Unhook the
Cover, carriage assembly
by pressing the part where the cover is mounted;
then push the cover backward to remove it.
Figure 6-2 Removing the Cover, carriage assembly
➊
➋
Cover, carriage
assembly
Cover, carriage
assembly