Specifications
Table Of Contents
- Confidentiality Agreement
- Chapter 1 - Specifications
- Chapter 2 - Outline of Operation
- M-J8000 printer mechanism
- Print mechanism
- Roll paper feed mechanism
- Slip feed mechanism
- Detector mechanisms
- Home-position detector mechanism
- Carriage detector mechanism
- Pump position detector mechanism
- Ink nearend detector mechanism
- Cartridge detector mechanism
- T.O.F. detector mechanism
- Paper-width detector
- B.O.F. detector mechanism
- Slip detector mechanism
- Shutter detector mechanism
- Roll paper detector mechanism
- Roll paper nearend detector mechanism
- Cover-open detector mechanism
- Cutter detector mechanism
- Autocutter mechanism
- Ink system mechanism
- Overview of electrical circuit
- M-J8000 printer mechanism
- Chapter 3 - Handling
- Chapter 4 - Maintenance and Inspection
- Chapter 5 - Repair and Troubleshooting
- Chapter 6 - Disassembly, Assembly, and Adjustment
6-22 Disassembly, Assembly, and Adjustment Rev. A
Confidential
Cables
Follow the steps below to disassemble the parts.
1. Remove the covers and the
Case, upper assembly
. See the “Covers and upper case”
section in this chapter.
2. Remove the
Mechanism assembly, M-J8000
. See the “Mechanism assembly, M-J8000”
section in this chapter.
3. Remove the
Case, lower assembly
. See the “Case, lower assembly” section in this chapter.
4. Disconnect the
FFC, L
,
FFC, R
,
FFC, head
,
Power switch assembly
,
Switch board
assembly
, and
DC cable assembly
.
Figure 6-31 Disconnecting the Cables
FFC, head
Power switch assembly
FFC, R
Switch board assembly
DC cable assembly
FFC, L