Specifications
Table Of Contents
- Confidentiality Agreement
- Chapter 1 - Specifications
- Chapter 2 - Outline of Operation
- M-J8000 printer mechanism
- Print mechanism
- Roll paper feed mechanism
- Slip feed mechanism
- Detector mechanisms
- Home-position detector mechanism
- Carriage detector mechanism
- Pump position detector mechanism
- Ink nearend detector mechanism
- Cartridge detector mechanism
- T.O.F. detector mechanism
- Paper-width detector
- B.O.F. detector mechanism
- Slip detector mechanism
- Shutter detector mechanism
- Roll paper detector mechanism
- Roll paper nearend detector mechanism
- Cover-open detector mechanism
- Cutter detector mechanism
- Autocutter mechanism
- Ink system mechanism
- Overview of electrical circuit
- M-J8000 printer mechanism
- Chapter 3 - Handling
- Chapter 4 - Maintenance and Inspection
- Chapter 5 - Repair and Troubleshooting
- Chapter 6 - Disassembly, Assembly, and Adjustment
Rev. A Handling 3-3
TM-J8000/J8000P Technical Manual
Confidential
Power switch fixed mode (power off command mode)
This mode allows use of the power off command. Do not use this command in standard mode or
IM interlock mode. The front and rear power switches always remain on.
To turn on the printer power, turn on the power breaker in the shop or the power strip for the
POS system. To turn off the printer power, you must send the power off command and make
sure the POWER LED goes out. Then turn off the power breaker.
CAUTION:
Be sure to use the power off command to turn off the printer. If this command is not sent,
drying of ink in the print head may cause printing problems.
IM interlock mode
In this mode, the rear and front power switches remain on, and power is turned on or off with
the IM-5*5 power switch. You must connect the power cord to the AC inlet and the DC power
cable from the IM-5*5 power supply unit to the IM interlock connector.
Note:
In this mode, the rear and front power switches are supposed to remain on. However, if you turn off these
switches, note the following things:
❏
The printer does not turn on if the front power switch remains off.
❏
The printer does not turn on if the front power switch or the IM-5*5 power switch is turned on before
the rear power switch is turned on.
Table 3-4 Power on/off using power switch fixed mode
Power ON Power OFF
1. The first time power is turned on for the
printer: First turn on the rear and front power
switches; then turn on the power breaker in
the shop or the power strip for the POS
system.
1. Send the power off command.
2. Whenever power is turned on subsequently,
use only the power breaker. (The rear and
front switches remain on.)
2. Be sure the POWER LED goes out.
3. Turn off the power breaker.
Table 3-* Power on/off in IM interlock mode
Power ON Power OFF
1. The first time power is turned on for the printer:
First turn on the rear and front power switches;
then turn on the IM-5*5 power switch.
Turn off only the IM-5*5 power switch.
2. Whenever power is turned on subsequently,
use only the IM-5*5 power switch. (The rear
and front switches remain on.)