Specifications
Table Of Contents
- Confidentiality Agreement
- Chapter 1 - Specifications
- Chapter 2 - Outline of Operation
- M-J8000 printer mechanism
- Print mechanism
- Roll paper feed mechanism
- Slip feed mechanism
- Detector mechanisms
- Home-position detector mechanism
- Carriage detector mechanism
- Pump position detector mechanism
- Ink nearend detector mechanism
- Cartridge detector mechanism
- T.O.F. detector mechanism
- Paper-width detector
- B.O.F. detector mechanism
- Slip detector mechanism
- Shutter detector mechanism
- Roll paper detector mechanism
- Roll paper nearend detector mechanism
- Cover-open detector mechanism
- Cutter detector mechanism
- Autocutter mechanism
- Ink system mechanism
- Overview of electrical circuit
- M-J8000 printer mechanism
- Chapter 3 - Handling
- Chapter 4 - Maintenance and Inspection
- Chapter 5 - Repair and Troubleshooting
- Chapter 6 - Disassembly, Assembly, and Adjustment
Rev. A Handling 3-15
TM-J8000/J8000P Technical Manual
Confidential
Note:
❏
The first ink charging is conducted automatically when the first ink cartridge is installed (when the
printer is turned on). Do not turn the printer power off during the charging. If the power is turned
off, the ink charging will be subsequently repeated, causing a remarkable reduction in ink cartridge
printing life. This operation takes approximately two minutes. The POWER LED blinks during the
ink charging and stays on as soon as the charging is complete.
❏
Do not remove the ink cartridge unless it is being replaced. A cleaning operation is conducted each
time the ink cartridge is removed, causing a reduction in the ink cartridge printing life.
❏
Press the CLEANING button to clean the head only if printing problems are being experienced. The
cleaning operation causes a reduction in the ink cartridge printing life.
❏
Do not turn off the power switch or open the printer cover while the POWER LED is blinking; head
cleaning or the ink charging is being conducted.
❏
Replace the ink cartridge while the printer is turned on. If the power is off during replacement,
defective printing may occur because the ink cartridge replacement is not correctly detected.
❏
Use the EPSON SJIC1 ink cartridge. The use of any other cartridge may cause damage to the printer.
Opening the Printer Cover
When you open the printer cover, pull it toward you a little, as shown below, then lift it up.
Figure 3-14 Opening the printer cover
➊
➋