Specifications
Table Of Contents
- Confidentiality Agreement
- Chapter 1 - Specifications
- Chapter 2 - Outline of Operation
- M-J8000 printer mechanism
- Print mechanism
- Roll paper feed mechanism
- Slip feed mechanism
- Detector mechanisms
- Home-position detector mechanism
- Carriage detector mechanism
- Pump position detector mechanism
- Ink nearend detector mechanism
- Cartridge detector mechanism
- T.O.F. detector mechanism
- Paper-width detector
- B.O.F. detector mechanism
- Slip detector mechanism
- Shutter detector mechanism
- Roll paper detector mechanism
- Roll paper nearend detector mechanism
- Cover-open detector mechanism
- Cutter detector mechanism
- Autocutter mechanism
- Ink system mechanism
- Overview of electrical circuit
- M-J8000 printer mechanism
- Chapter 3 - Handling
- Chapter 4 - Maintenance and Inspection
- Chapter 5 - Repair and Troubleshooting
- Chapter 6 - Disassembly, Assembly, and Adjustment
3-18 Handling Rev. B
Confidential
Front power switch cover
The illustration below shows the front power switch cover installed.
Figure 3-17 Front power switch cover
If you need to turn the power on or off when the cover is installed, you can insert a thin tool into
one of the holes in the cover to operate the switch.
Rear power switch cover
The illustration below shows the rear power switch cover installed. Notice that you must
remove a screw from the connector panel and then use it to fasten the switch cover in place.
Figure 3-18 Rear power switch cover
Removing Paper Jams
Paper jams near the head
1. Open the printer cover.
2. Use the shutter OPEN/CLOSE gear to open the shutter, if necessary.