Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
188 187
TM-L90
Specification
(STANDARD)
E
[Notes] • Although you can set this command, full cut or one point left uncut cannot be changed by
software.
• If the printer cuts the paper and feeds to the print starting position immediately when the
printer feeds to the peeling position, the paper may be pulled inward and the printer may not
be able to feed. Therefore, it is prohibited to use this command immediately when the
printer feeds to the peeling position.
GS W n
L
n
H
[Name] Set printing area width
[Format] ASCII GS W n
L
n
H
Hex 1D 57 n
L
n
H
Decimal 29 87 n
L
n
H
[Range] 0 ≤ n
L
≤ 255
0 ≤ n
H
≤ 255
[Default] When the paper layout (the origin of the layout) is set to “does not use the layout” or “top of the
black mark”:
(n
L
+ n
H
× 256) = 576 (n
L
= 64, n
H
= 2) (for 80 – 78 mm of the paper width)
(n
L
+ n
H
× 256) = (256 + (paper width – 38) × 8) (for 77 – 38 mm of the paper width)
When the paper layout (the origin of the layout) is set to “bottom of the label”:
(n
L
+ n
H
× 256) = 560 (n
L
= 48, n
H
= 2) (for 80 mm of the paper width)
(n
L
+ n
H
× 256) = (224 + (paper width – 38) × 8) (for 79 – 38 mm of the paper width)
[Description] Sets the printing area width specified with n
L
and n
H
.
•
The printing area width is [(n
L
+ n
H
× 256) × (horizontal motion units)].
GS \ n
L
n
H
[Name] Set relative vertical print position in page mode
[Format] ASCII GS \ n
L
n
H
Hex 1D 5C n
L
n
H
Decimal 29 92 n
L
n
H
[Range] 0 ≤ n
L
≤ 255
0 ≤ n
H
≤ 255
[Description] Sets the relative vertical print starting position from the current position in page mode. The
distance from the current position to the starting position is [(n
L
+ n
H
× 256) × (vertical or
horizontal motion units) ].