Specifications

Confidential
5
SHEET
App. 5
NO.
SHEET
REVISION
E
TITLE
NEXT
App. 6
TM-L90
Specification
(STANDARD)
APPENDIX C: ADJUSTING THE ROLL PAPER NEAR-END SENSOR
LOCATION
The remaining detectable amount of paper on the paper roll varies with the inside and outside
diameters of the paper core. The minimum detectable amount of paper on the paper roll can be
set using the following method:
1) The inside diameter of the paper spool should be 25.4 mm {1.00"} and the outside diameter
of the paper spool should be 31.4 mm {1.24"}. Specified thermal paper should be used.
2) Loosen the adjusting screw that holds the paper near-end sensor and set the top of the
positioning plate to the appropriate adjustment value and tighten the adjusting screw.
Table C.1 Adjustment Positions
Adjustment position number Specified thermal paper
Dimension of outside diameter of paper roll
#1 Approximately 36 mm {1.42"}
#2 Approximately 41 mm {1.61"}
Positioning Plate #1 Horizontal Positioning Plate #2 Horizontal
Positioning Plate #1 Vertical Positioning Plate #2 Vertical
Figure C.1 Near-end Adjusting Position