Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
14 13
TM-L90
Specification
(STANDARD)
E
2) Die-cut Labels (face stocks)
Make a margin of 2.8 mm {0.11"} or more from the label edges on both left and right sides as the
printable area of the label (face stock).
Label (face stock) width
1.5 or more
Printable area
2.8 or more
[Units: mm]
2.8 or more
Liner width
1.5 or more
Figure 1.7.2 Printable Area (for Labels)
NOTES: • If the margins are not set, the printing may be off the label due to paper misalignment or
the parts tolerance.
• A label which has a 71 to 79 mm of the liner width cannot be used because of the
thickness of the paper roll spacer.
Table 1.7.2 Example of Liner Width and Printable Area
Liner width (mm) (80) (70) (60) (50) (45) (38)
Label (face stock)
width (mm)
76 66 56 46 41 34
Printable area (mm) 70 60 50 40 35 28
Left margin (mm) 2.9 2.9 2.9 2.9 2.9 2.9
Right margin (mm) 3.1 3.1 3.1 3.1 3.1 3.1
Positioning dot
number
17 ∼ 576 17 ∼ 496 17 ∼ 416 17 ∼ 336 17 ∼ 296 17 ∼ 240
Total number of dots 560 480 400 320 280 224
(The label must be positioned in the center of the liner. Numeric values used here are center values in
designing. Only paper width is for nominal dimension. The values in parenthesis are the maximum
value for the paper tolerance.)