Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
19 18
TM-L90
Specification
(STANDARD)
E
4) Impact resistance: When packed: Package: EPSON standard package
Height: 60 cm {23.62"}
Directions: 1 corner, 3 edges, and 6 surfaces
No external or internal damage should be found after the drop test, and
the unit should operate normally.
When unpacked: Height: 5 cm {1.97"}
Directions: Lift one edge and release it
(for all 4 edges).
When the printer is not printing, no external or internal damage should
be found after the drop test.
5) Acoustic noise (operating): Approximately 53 dB (ANSI bystander position)
NOTE: The value as shown above is measured when the EPSON evaluation printing pattern is
used. This value may be different, depending on the paper to be printed, the print duty, or
the print conditions, such as the print speed or the print density.
1.14 Installation
The TM-L90 series printer can be installed horizontally or vertically.
When installing the printer horizontally using an autocutter with a full cut, attach the paper exit guide
packed in the printer’s box to the printer, and change the location of the paper roll near-end sensor
(refer to Appendix C).
(Vibration during paper cutting and using a drawer should be considered. Take measures to prevent
the printer from moving. Affixing tapes are provided as an option.)
An optional hanging bracket can attach the printer to a wall. (Follow the procedure described in the
user’s manual to install the wall mount.)