Specifications

Chapter 2 Setup
43
2
Connecting the Printer
The TM-P60II has dual interfaces: a built-in USB interface and another interface selected by the customer,
wireless LAN or Bluetooth interface. See the corresponding section for the interface you selected.
•Wi-Fi models: "USB Interface" on page 43 or "Wireless LAN Interface" on page 44
•Bluetooth models: "USB Interface" on pag e 43 or "Bluetooth Interface" on page 45
USB Interface
1
Attach the enclosed wire saddle to the printer as shown in the picture
below.
2
Put the USB cable through the wire saddle.
3
Connect the USB cable from the host computer to the USB upstream
connector.
4
Connect the other end of the interface cable to the host computer.
• Before connecting the printer, confirm the current interface mode. The printer is initially
set to the Automatic selection mode. To change the interface mode, see "Software
Settings" on page 46.
• Automatic selection:
When the USB cable is connected with a host PC, the USB interface is preferentially
selected. Otherwise, the wireless LAN/Bluetooth interface is selected. Once the
interface is selected, the selection is enabled until the power is turned off or the USB
cable is disconnected.
• Putting the USB cable through the wire saddle prevents the cable from coming
unplugged.
• Do not place any weight or stress on the cable when using. Doing so could damage the
cable and connectors.
Wire saddle