Specifications

44
Wireless LAN Interface
If your printer is a Wi-Fi model, wireless LAN connection is available. Use EpsonNet Config,
which is a utility for wireless LAN settings by following the steps below.
1
Connect the printer to a PC via the USB cable.
See "USB Interface" on page 43.
2
Turn on the printer.
3
Start up EpsonNet Config.
4
Double-click on the printer.
• Examine the radio wave situation in the surrounding area before use.
• Avoid using the same channel that is used in the neighboring shops where wireless LAN
is used.
• In the infrastructure mode, W53 and W56 channels are not available to connect to a
stealth SSID access point.
• For detailed information about EpsonNet Config, see the EpsonNet Config Operations
Guide.
• If you configure the wireless LAN setting without using EpsonNet Config, use the
network parameters printed on the status sheet. To print status sheet, see "Status Sheet
Print Mode (Only for Wi-Fi Models)" on page 72.
• The network parameters are initially set as follows:
∗ Communication standard: 802.11b/g/n
∗ Network mode: Infrastructure
∗ SSID: EpsonNet
∗ Security level: WPA-PSK (AES)
∗ Passphrase: EpsonNet
∗ IP Address: 192.168.192.168
∗ Subnet mask: 255.255.255.0
• To initialize the wireless LAN setting, see "Wireless Communication Setting Initializing
Mode" on page 70.