Specifications

62
Settings
Select from the menu list on the left to check or configure the settings.
Information menu
You can check the settings as shown in the table below.
• When using a certificate, be sure to use the time server. Otherwise, the time is initialized
when the power is turn off, and the validity of the certificate cannot be checked.
• Set the valid period of self-signed certificate before January 1 2038.
• Time setting is necessary when using the certificate. Enable the Time Server and set the
time within the valid period of the certificate using UTC for the default setting of time.
Otherwise, the time is initialized when the power is turn off, and the wireless LAN is no
longer possible.
• When the certificate has expired, the wireless LAN connection is no longer possible. In
that case, use the EpsonNet Config using the USB connection to disable the certificate
function. And then, use EpsonNet Config (web version) to set the certificate.
Menu Settings
Basic Information
Administrator Name, Location, interface Card Model Name,
MAC Address, Hardware Version, Software Version, Model
Name,
Communication Standard, Network Mode, SSID, Channel,
Transmission Rate, Access Point MAC Address, Signal Condition,
Printer Status
TCP/IP
IPv4 Address
IP Address Settings (Acquiring the IP Address, IP Address,
Subnet Mask, Default Gateway)
Set Using Automatic Private IP Addressing (APIPA)
DNS/DDNS
DNS Server Addresses (IPv4) Settings (Acquire DNS Server
Address Automatically, DNS Server Addresses)
Domain Name Setting (Acquire Domain Name Automatically,
Fully Qualified Domain Name, Register the Network Interface’s
Address to DNS Server)
SNMP
Community (Read Only)
IP Trap (Trap1/2, Address, Community)
Bonjour
Bonjour (Disable/Enable)
Bonjour Name, Bonjour Printer Name, Location
Time Setting
Use Time Server
Time Server Address, Update Interval, Time Server Status
Timeout Print (LPR, RAW (Port9100))
ePOS-Print Version, ePOS-Print (Disable/Enable), Device ID