Specifications

Confidential
1
TM-P60
Specification
(STANDARD)
TITLE
SHEET
REVISION
E
NO.
NEXT SHEET
App.2 App.1
APPENDIX A: MISCELLANEOUS NOTES
A.1 Notes on Printing and Paper Feeding
1) Because the TM-P60 series printer is a line printer, it automatically feeds paper after printing
the data.
Therefore, when the line spacing for one line is set to a smaller value than the height of the
print data, paper may be fed more than the set amount just to print the data.
Table A.1 Paper Feeding Amount (ANK Model)
Required paper feeding amount (dots)
Font A
24 × number of times enlarged vertically
Font B
24 × number of times enlarged vertically
Font C
16 × number of times enlarged vertically
Table A.2 Paper Feeding Amount (Japanese Model)
2) When the printer goes to the standby (data-waiting) state during printing, it temporarily stops
printing and feeding paper. When data is transmitted and printing is executed, paper may
shift 1 to 3 dots from the print starting position, which especially affects graphics.
3) Interval of autocutting operation in the receipt section
For driving the autocutter of the receipt section, the interval should be a minimum of 10 lines
of printing or paper feeding (to prevent small pieces of cut paper from dropping into the
autocutter).
A.2 Notes on Printer Installation
• Connect the external power supply to the power supply connector of the printer. Then plug in
the external power supply and turn it on if necessary. Be sure not to connect the external
power supply with the wrong polarity. If it is connected incorrectly, the internal circuit fuse of
the printer may be blown or the external power supply may be damaged.
• Both high and low voltage errors are shown in Table 3.6.3. The flashing patterns are shown
in the table.
• When either a high or low voltage error occurs, turn off the power as soon as possible.
Required paper feeding amount (dots)
Font A
24 × number of times enlarged vertically
Font B
24 × number of times enlarged vertically
Font C
16 × number of times enlarged vertically
Kanji font A
24 × number of times enlarged vertically
Kanji font B
24 × number of times enlarged vertically
Kanji font C
16 × number of times enlarged vertically